ADDERLink X-DVI PRO-DL
Dual link resolutions deliver uncompressed digital video with audio to a remote screen up to 50m away, with USB 2.0 connection to interface with a range of devices.
Part of the ADDERLink® X-DVI PRO range, the X-DVI PRO-DL high-performance, digital KVM (Keyboard, Video and Mouse) and USB extender enables you to locate your critical computing hardware in a secure and temperature controlled environment. Uncompressed digital video and audio is distributed in real-time and with zero latency via a Dual Link DVI video stream, allowing the user to maintain an at-the-PC experience. The USB 2.0 interface ensures compatibility with a wide range of USB devices.
• Dual Link resolutions: deliver uncompressed digital video with audio
• USB 2.0 Low and Full speed connection: to interface with a range of devices
• Exact content seen on the local monitor is distributed: up to 50m over a single CATx cable
• Energy efficient design: external power supplies are not needed
• X-DVI PRO-DL: enables single screen at 2560 x 1600@60Hz
Dual Link resolutions for pixel perfect digital video with real time control
Using uncompressed video extension; no visible artefacts or latency are introduced allowing you to be certain of quality and control
Distribution up to 50m over a single CATx cable
Video, USB 2.0 (Low and Full speed) and audio all pass along a single cable, providing up to 50m of extension with resolutions up to 2560x1600@60Hz (distance dependent upon video resolution, CATx cable type, and number of connection intervals)
USB 2.0 enables connection of any USB interface device
From mice and keyboards through to graphics tablets, jog shuttles, joysticks, 3D explorers and mass storage devices. Support for Full speed (12Mbps) isochronous devices, e.g. headsets
HDMI video and audio extension capabilities
Digital audio for 8 channels of HDMI audio, supported simultaneously to analog audio
Stereo analog audio
Stereo channel 16bit sampled at 44.1kHz to transfer audio from local to remote for line out
Transmitter unit can be powered solely from the host computer’s USB connection
Extended Display Identification Data (EDID) enables the remote system to exactly mirror the date coming from the source monitor
Plug and Play
ADDERLink X-DVI PRO extenders are delivered in a zero config state so they work as soon as they are connected, without the need for drivers or software
Robust yet lightweight
Small form factor, rack mountable device
The system delivers analog stereo audio (Line Out). 8 channels of HDMI audio are supported with sample sizes of 16, 20 or 24bits at 32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, or 192kHz (simultaneously with the jack audio).
Approvals / Compliance
DVI-D Interface – digital only the system supports resolutions to a maximum of 2560x1600 @60Hz.
Hardware compatibility: All computers with DVI-D, USB and audio - requirement dependent.
Recommended cables are CAT7 shielded foiled twisted pairs:
- Daetwyler 7702 Flexible patch cable
- Daetwyler 7120 Bulk cable
CAT5 (or better) shielded twisted pair cable must be used to connect the local and remote units in order to maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of immunity to electromagnetic disturbances. Distances are achieved using single lengths of trunk/bulk cable.
For each break/patch connection reduce distance by 5m. Preferably patch cables should be of type CAT7a and less than 2m. Patch cables over 2m must be CAT7a. The maximum extension distance for USB is 50m including connections to and from the X-DVI PRO DL independent of cable type. If a USB hub is connected to the RX unit, this is seen as 5m of cable length. This needs to be taken into consideration when planning your system.
CAT5e is not recommended for use with this system.
Operating Temperature: 0 to 40ºC / 32 to 104ºF
Connectors – Local Unit
DVI-D, Audio 3.5mm in, USB type B
Connectors – Remote Unit
DVI-D, Audio 3.5mm out, USB type A x 4.
Compact case, robust metal construction 120mm / 4.7’’ (w) x 75mm / 3’’(d) x 26mm / 1’’ (h) 320g / 0.7 lb
Rx: 2.5mm DC jack (power adapter included),100-240V AC 50/60Hz, 0.4A, input to power adapter, 5VDC 12.5W output from power adapter. TX: Powered from single USB connection. Optional 2.5mm DC jack (power adapter not included).
Compatible with all known operating systems
Nikt jeszcze nie napisał recenzji do tego produktu. Bądź pierwszy i napisz recenzję.